Bissoy.com
Doctors Medicines MCQs Q&A

How many guide bearings are used along with the simple thrust bearings to pick up radial loads?

How many guide bearings are used along with the simple thrust bearings to pick up radial loads? Correct Answer 2 or 3

The simple thrust bearing cannot pull the radial load and hence guide bearings are used in addition to it. Usually 2-3 guide bearings are used in vertical shaft machines depending upon the load.

Related Questions

Consider the following statements in connection with thrust bearings: 1) Cylindrical thrust bearings have higher coefficient of friction than ball thrust bearings. 2) Taper rollers cannot be employed for thrust bearings. 3) Double-row thrust ball bearing is not possible 4) Lower race, outer race and retainer are readily separable in thrust bearings. Which of the above statements are correct?
Which one of the following four addresses is NOT EXACTLY the same as the one given below? Adirondack Rock & River Guide Service, Inc. P.O. Box 219 Keene, New York 12942 (518) 576­ - 2041 (i) Adirondack Rock & River Guide Service, Inc. P.O. Box 219 Keene, New York 12942 (518) 576­ - 2041 (ii) Adironduck Rock & River Guide Serivce, Inc. P.O. Box 219 Keene, New York 12942 (518) 576 - ­2041  (iii) Adirondack Rock & River Guide Service, Inc. P.O. Box 219 Keene, New York 12942 (518) 576 - ­2041 (iv) Adirondack Rock & River Guide Service, Inc. P.O. Box 219 Keene, New York 12942 (518) 576 - ­2041 
Rocket A has twice the pressure thrust of rocket B while it has half the momentum thrust as that of B. If the momentum thrust of B is 5 times its pressure thrust, find the ratio of total thrust of A to B.
Which of the following statements is true? A. Impact loads are equal to the sum of the magnitude of the loads actually caused and the magnitude of the loads had they been dead loads. B. Impact loads are equal to the difference between the above-mentioned entities.
Impact loads are equal to the sum of the magnitude of the loads actually caused and the magnitude if the loads had they been dead loads. State whether this statement is true or false.
For radial equilibrium flow radial component must be _______ along the radial direction of flow.
Humayun is asked to write a guide for GMAT exam preparation. For his work the publishing company giving him a choice of a one time payment of tk. 25,625 or tk.15.75 per guide sold.How many guide need to be sold for the totsl income received by Humayun to be the same from either choice?
A rider is riding his bike along the sides of a square ground. He drives the bike with the speed of 10 km/h along one side, 15 km/h along another side, 18 km/h along the third side, and 20 km/h along the last side and reaches the starting point. What is the average speed of the bike along the sides of the ground?
What is the additional setup provided to the simple thrust bearing when it is not able to take up radial loads?
Consider the following statements in connection with hydraulic turbines: 1. The Kaplan turbine is a radial flow turbine in which the guide vane angles as well as the runner vane angles are adjustable. 2. Francis and Kaplan turbines are provided with draft tubes which carry water from exit of runner to tail water to increase the gross head across the turbine. 3. The parts of turbines susceptible to cavitation are the guide vanes and runner vanes – drastically reducing the turbine efficiency. 4. The specific speed of a 4-jet Pelton turbine will be 28 if the specific speed of a single-jet Pelton turbine is 14. Which of the above statements are correct?