Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Find the operating line slope Where, X,Y- concentration in mole ratio of liquid and gas phase x,y-concentration in mole fraction Gs,Ls- mole free basis( non-diffusing solvent)
Two feeds, 10 mole with 5 J/mole and 20 mole with 15 J/mole, product contains two streams, 5 mole with 10 J/mole and P with 25 J/mole, what is the value of P?
Two feeds, 5 mole with 25 J/mole and F with 5 J/mole, product contains two streams, 5 mole with 10 J/mole and 10 mole with 15 J/mole, what is the value of F?
A very dilute solution is prepared by dissolving 'x1' mole of solute in 'x2' mole of a solvent. The mole fraction of solute is approximately equal to
In a wetted-wall tower, an air-H2S mixture is flowing by a film of water which is flowing as a thin film down a vertical plate. The H2S is being absorbed from the air to the water at a total pressure of 1.50 atm abs and 30oC. The value of kc of 9.567×10-4 m/s has been predicted for the gas-phase mass-transfer coefficient. At a given point the mole fraction of H2S in the liquid at the liquid-gas interface is 2.0×10-5 and pA of H2S in the gas is 0.05 atm. The Henry’s law equilibrium relation is pA(atm) = 609xA (mole fraction in liquid). Calculate the rate of absorption of H2S.
What is the enthalpy change of 8 mole solution if the enthalpy change of 5 mole solute is 10 J/mole, and enthalpy of 2 mole solvent is 15 J/mole?
The vapor pressure of the solvent decreased by 10 mm Hg, when a non-volatile solute was added to the solvent. The mole fraction of the solute in the solution is 0.2. What should be the mole fraction of the solvent, if the decrease in vapor pressure of the solvent is required to be 20 mm Hg.?
Statement 1: Boiling point concentration diagram plots y against x. (Mole fraction in gas and liquid phase respectively). Statement 2: VLE curve plots y against x. (Mole fraction in gas and liquid phase respectively).
Three feeds, 10 mole with H = 5 J/mole, 10 mole with H = 15 J/mole and 5 mole with 20 J/mole, what is the enthalpy of the products?
Three feeds, 10 mole with H = 25 J/mole, 5 mole with H = 10 J/mole and 15 mole with 20 J/mole, what is the enthalpy of the products?