Bissoy.com
Doctors Medicines MCQs Q&A

A copper coil has a resistance of 200 ohms when its mean temperature is 0 degree centigrade. Calculate the resistance of the coil when its mean temperature is 80 degree centigrade. Temperature coefficient of copper is 0.004041 centigrade-1

A copper coil has a resistance of 200 ohms when its mean temperature is 0 degree centigrade. Calculate the resistance of the coil when its mean temperature is 80 degree centigrade. Temperature coefficient of copper is 0.004041 centigrade-1 Correct Answer 264.65 ohm

R=R0(1+α dT) = 200(1+ 0.004041*80) = 264.65 ohm.

Related Questions

The rear window of an automobile is made of thick glass i.e. AB = 5 mm and thermal conductivity is 0.8 W/m degree. To defrost this window, a thin transparent film type heating element has been fixed to its inner surface. For the conditions given below, determine the electric power that must be provided per unit area of window if a temperature 5 degree Celsius is maintained at its outer surface. Interior air temperature and the corresponding surface coefficient are 20 degree Celsius and 12 W/m2 degree. Surrounding air temperature and the corresponding surface coefficient are – 15 degree Celsius and 70 W/m2 degree. Electric heater provides uniform heat flux
Let D be a simple graph on 10 vertices such that there is a vertex of degree 1, a vertex of degree 2, a vertex of degree 3, a vertex of degree 4, a vertex of degree 5, a vertex of degree 6, a vertex of degree 7, a vertex of degree 8 and a vertex of degree 9. What can be the degree of the last vertex?
For a 7.46 kW, 200 V dc shunt motor with full load efficiency of 85% has armature resistance of 0.25 ohms. Calculate the value of starting resistance in ohms for a current 1.5 times of the full load current.
Three resistances of 15 ohms, 10 ohms and 30 ohms are connected in a parallel combination, then What is its equivalent resistance ?
Three resistances of 10 ohms, 15 ohms and 30 ohms are connected in parallel.
The total resistance of the combination is
You have a 2 milliampere meter movement with a coil resistance of 1000 ohms. When 2 milliampere is flowing through the meter coil and is causing FSD, what will be the voltage developed across the coil resistance?
An average convective heat transfer coefficient for flow of air over a sphere has been measured by observing the temperature-time history of a 12 mm diameter copper sphere (density = 9000 kg/m3 and c = 0.4 k J/kg K) exposed to air at 30 degree Celsius. The temperature of the sphere was measured by two thermocouples one located at the center and the other near the surface. The initial temperature of the ball was 75 degree Celsius and it decreased by 10 degree Celsius in 1.2 minutes. Find the heat transfer coefficient
Study the following statements.i) The displacement method is more useful when degree of kinematic indeterminacy is greater than the degree of static indeterminacy.ii) The displacement method is more useful when degree of kinematic indeterminacy is less than the degree of static indeterminacy.iii) The force method is more useful when degree of static indeterminacy is greater than the degree of kinematic indeterminacy.iv) The force method is more useful when degree of static indeterminacy is less than the degree of kinematic indeterminacy.The correct answer is
Refer the diagram; a single-phase supply of 100V, 50Hz is fed to the step-up transformer having primary impedance of 1 ohms and secondary impedance 20 ohms. What is the power consumed by the load of 5 ohms?
A very long copper rod 20 mm in diameter extends horizontally from a plane heated wall maintained at 100 degree Celsius. The surface of the rod is exposed to an air environment at 20 degree Celsius with convective heat transfer coefficient of 8.5 W/m2 degree. Workout the heat loss if the thermal conductivity of copper is 400 W/m degree