Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the string abbccddeee. Each letter in the string must be assigned a binary code satisfying the following properties: 1. For any two letters, the code assigned to one letter must not be a prefix of the code assigned to the other letter. 2. For any two letters of the same frequency, the letter which occurs earlier in the dictionary order is assigned a code whose length is at most the length of the code assigned to the other letter. Among the set of all binary code assignments which satisfy the above two properties, what is the minimum length of the encoded string? 
A particular BNF definition for a “word” is given by the following rules. ∷ = | | ∷ = |  ∷ = |  ∷ = a | b | c | ….. |y| z  ∷ = 0 |1|2| …… | 9 Which of the following lexical entries can be derived from < word > ? l. pick II. picks lll. c44
Using the string of letters given below, choose the letter that comes second to the right of the letter which is immediate to the left of the letter that comes third to the right of the letter that comes midway between the letter second to the left of the letter C and the latter immediately to the right of the letter F. ABCDEFGH 
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
Arrange the letter of the word 'PERIPHERAL' in alphabetic order and then interchange the letters at first and second, third and fourth and so on. Now replace the letter at odd place with the previous letter in alphabetic series and letter at even place with the next letter in the alphabetic series. After this arrangement which letter will be at the sixth position from the right end? 
If in the word 'DISTURBANCE', the first letter is interchanged with the last letter, the second letter is interchanged with the tenth letter and so on, which letter would come after the letter T in the newly formed word ?
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10