Bissoy.com
Doctors Medicines MCQs Q&A

The non-dimensional parameter known as Stanton number is used in which of the following heat transfer?

The non-dimensional parameter known as Stanton number is used in which of the following heat transfer? Correct Answer Forced convection heat transfer

It’s the ratio of the heat transfer coefficient to the heat flow per unit temperature rise caused by fluid velocity. It can only be used for forced convection heat transfer.

Related Questions

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as
A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as
The non-dimensional parameter known as Stanton number is used in
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the number of transfer units of the heat exchanger. At the condensing pressure, stream has saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to water. Take specific heat of water as 4 k J/kg K
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
Consider the following statements regarding heat waves in India.  I. Heat waves mostly occur over Rajasthan, Punjab and Haryana towards the end of April but they mainly take place in May.  II. Any heat wave lasts for around 4-5 days.  III. If there is an increase in temperature by 6-7 degrees Celsius above normal, that is known as the Moderate Heat Wave whereas if it is 8 degree Celsius or more, that is known as Severe heat wave.  Which among the above statements is/are correct regarding the heat waves?
A Carnot heat engine receives heat at 750 K and rejects the waste heat to the environment at 300 K. The net work output of the heat engine is used to drive a Carnot refrigerator, whose COP is 6.14. If the heat removal rate from the refrigerated space is 6.6 kW, determine the rate of heat supply to the heat engine?
The scales form in heat exchanges after a period of operation and provide additional resistance to heat transfer with some heat transfer coefficient . The reciprocal of this scale heat transfer coefficient is called .
There are two rows, each containing 3 numbers. Below are some rules to be used to get the resultant number for each row separately. Use the rule from left to right for each row and find the answer to the question. Rule: 1. If an even number is followed by an even number, then the first number will be subtracted from the second. 2. If an odd number is followed by an odd number, then both will be added. 3. If an odd number is followed by an even number, then the even number will be subtracted from the square of the odd number. 4. If an even number is followed by an odd number, then the odd number will be subtracted from the even number. Row I: 9,11, 34 Row II: 16, 9, 8 What is the difference between the resultant numbers in the first row and the second row