Bissoy.com
Doctors Medicines MCQs Q&A

A thin metal plate of 4 cm diameter is suspended in atmospheric air whose temperature is 290 K. This plate attains a temperature of 295 K when one of its faces receives radiant energy from a heat source at the rate of 2 W. If heat transfer coefficient on both surfaces of the plate is stated to be 87.5 W/m 2 K, workout the reflectivity of the plate.

A thin metal plate of 4 cm diameter is suspended in atmospheric air whose temperature is 290 K. This plate attains a temperature of 295 K when one of its faces receives radiant energy from a heat source at the rate of 2 W. If heat transfer coefficient on both surfaces of the plate is stated to be 87.5 W/m 2 K, workout the reflectivity of the plate. Correct Answer 0.45

Heat loss by convection from both sides of the plates = 2 h A d t = 1.1 W. Energy lost by reflection = 2.0 – 1.1 = 0.9 W.

Related Questions

A thin metal plate of 4 cm diameter is suspended in atmospheric air whose temperature is 290 K. This plate attains a temperature of 295 K when one of its face receives radiant energy from a heat source at the rate of 2 W. If heat transfer coefficient on both surfaces of the plate is stated to be 87.5 W/m 2 K, workout the reflectivity of the plate
A thin metal plate of 4 cm diameter is suspended in atmospheric air whose temperature is 290 K. This plate attains a temperature of 295 K when one of its face receives radiant energy from a heat source at the rate of 2 W. If heat transfer coefficient on both surfaces of the plate is stated to be 87.5 W/m 2 K, workout the energy lost by reflection
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
To effect a bond between two metal plates, 2.5 cm and 15 cm thick, heat is uniformly applied through the thinner plate by a radiant heat source. The bonding must be held at 320 K for a short time. When the heat source is adjusted to have a steady value of 43.5 k W/m2, a thermocouple installed on the side of the thinner plate next to source indicates a temperature of 345 K. Calculate the temperature gradient for heat conduction through thinner plate. In the diagram, the upper plate is 2.5 cm thick while the lower is 15 cm thick.
Experimental results indicate that the local heat transfer coefficient h g for flow over a flat plate with an extremely rough surface is approximated by the relation h x = a x -0.12 Where a is a constant coefficient and x is distance from the leading edge of the plate. What is the relation between this local heat transfer coefficient and the average heat transfer coefficient for a plate of length x?
A polished metal pipe 5 cm outside diameter and 370 K temperature at the outer surface is exposed to ambient conditions at 295 K temperature. The emissivity of the surface is 0.2 and the convection coefficient of heat transfer is 11.35 W/m2 degree. Calculate the overall coefficient of heat transfer by the combined mode of convection and radiation
Ten people are sitting in two parallel rows 1 and 2. A, B, C, D and E are sitting in row I facing south, and V, W, X, Y and Z are sitting in row 2 facing north, in such a way that each member in row 1 faces a member of row 2. W sits second from the left end of the row. W faces an immediate neighbour of A. B sits second to the left of A. Only one person sits between C and the one who faces V. Neither C nor V sit at any of the extreme ends. V faces an immediate neighbour of D. The one who faces E sits to the immediate left of X. Only one person sits between Y and X. Who faces Z?
In a counter flow heat exchanger, water flowing through a tube of 10 cm inner diameter is heated by steam condensing on the outside of the tube. The convective film coefficient on the water and steam side are estimated to be 12000 and 20000 k J/m2 hr degree. Neglecting tube thickness and its resistance to heat flow, workout the overall heat transfer coefficient for the heat exchanger
A cube of volume 64 cm3 is is cut into two smaller and identical cuboids. The faces of dimensions 4 × 4 of one of the cuboids are painted with black color and the rest of its faces are painted with yellow color. One pair of adjacent faces that do not include any face of dimensions 4 × 4 of the other cuboid are painted with yellow color and the rest of its faces are painted with black color. Now each of two cuboids are cut into 32 smaller and identical cubes. How many of the smaller cubes have exactly three colored faces?
An average convective heat transfer coefficient for flow of air over a sphere has been measured by observing the temperature-time history of a 12 mm diameter copper sphere (density = 9000 kg/m3 and c = 0.4 k J/kg K) exposed to air at 30 degree Celsius. The temperature of the sphere was measured by two thermocouples one located at the center and the other near the surface. The initial temperature of the ball was 75 degree Celsius and it decreased by 10 degree Celsius in 1.2 minutes. Find the heat transfer coefficient