Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is a discontinuity that occurs during the casting of molten metal and is caused by splashing, surging, or interrupted pouring?

Which of the following is a discontinuity that occurs during the casting of molten metal and is caused by splashing, surging, or interrupted pouring? Correct Answer Cold shut

Cold shut refers to a discontinuity in molten metal casting that can be generated by splashing, surging, halted pouring, or the meeting of two streams of metal coming from separate directions.

Related Questions

A discontinuity that occurs during the casting of molten metal which may be caused by the splashing, surging, interrupted pouring is ___________
Consider the following statements: 1. The discontinuity between the crust and the hydrosphere is known as the Conrad Discontinuity. 2. Crust is the outermost liquid part of the earth, normally about 1-20 kms thick. 3. The core is separated from the mantle by Guttenberg’s Discontinuity. 4. The discontinuity between the upper mantle and the lower mantle is known as Repetti Discontinuity. Which of the statements given above is/ are correct?  
In centrifugal casting, a movable pouring basin is employed for the pouring of molten metal.
Which of the following pairs of 'Discontinuities in earth's interior - Zones of the eart' is correct? I. Repetti Discontinuity - Upper and lower mantle II. Moho Discontinuity - Upper and lower crust III. Guttenberg Discontinuity - Outer and inner core
A geometrical discontinuity in a body, such as a hole or a notch result in nonuniform distribution of stress at the vicinity of discontinuity. At the region near the discontinuity, the local stress will be higher than normal stress distribution.
During the pouring process, filling time of molten metal should be short to avoid early solidification of the casting.
The casting can be defined as pouring of molten metal into a mould and taking it out after it becomes vapor.
In a casting process, a vertical channel through which molten metal flows downward from pouring basin to runner for reaching the mold cavity is called
In the squeeze casting method, extreme care is taken while pouring of molten metal into the die cavity.
If a gas metal arc process uses a low arc voltage and the arc is continuously interrupted as the molten electrode metal fills up the arc gap is known as