Bissoy.com
Doctors Medicines MCQs Q&A

Cutting the sympathetic nerves to the urinary bladder may cause

Cutting the sympathetic nerves to the urinary bladder may cause Correct Answer Loss of tone in intemal sphincter, Loss of pain sensation in bladder, Over active bladder

Related Questions

Study the following statements about the human excretory system. I. The waste materials dissolved in water are separated in the kidney as urine. II. Urine is stored in the bladder. It is passed out through the urethra, the other end of which is attached to the urinary aperture. III. Urine passes into the bladder through the urinary ducts. IV. Useful substances are reabsorbed into the blood. V. Blood containing both useful and harmful substances reaches the kidneys for filtration. The correct sequence of processes given in the above statements is:
In a certain code language - "Nerves is sense" is coded as "89 91 5", "sense are organ" is coded as "5 81 10", "organ is hand" is coded as "91 10 17" and "nerves are head" is coded as "89 81 11". What is the coded "nerves are head"?
Below each question are given two statements (I) and (II). These statements may be either independent causes or may be effects of independent causes or a common cause. One of these statements may be the effect of the other statement. Read both the statements and decide which of the following answer choice correctly depicts the relationship between these two statements. (I) In the event, the task of infusing substance into the June 2016 vote has led hard-line eurosceptics to purge moderate MPs, sympathetic to a softer exit. (II) The rightward shift has enabled the current leadership to position the Conservatives as the predominant force for Brexit, as opposed to Nigel Farage's Brexit Party.
Consider the following statements: 1. HSS tools wear very rapidly, whereas in cemented carbide tools, even though hardness is retained, crater wear can occur due to solid-state diffusion. 2. Cutting tools made of Super-HSS, also known as cobalt-based HSS, are made by adding 2% to 15% of cobalt which increases the cutting efficiency at heavier cuts by increasing the hot hardness and wear resistance. 3. Tools failure due to excessive stress can be minimized by providing small or negative rake angles on brittle tool materials, protecting tool tip by providing large side-cutting edge angles, and honing a narrow chamfer along the cutting edge. Which of the above statements are correct?
Flank wear occurs mainly on the 1. Nose part of the cutting tool 2. Front relief face and side relief face of the cutting tool 3. Face of the cutting tool at the shortest distance from the cutting edge Which of the above is/are correct?
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image