Related Questions

Gold is 19 times as heavy as water and Copper is 9 times as heavy as water. Calculate the ratio in which these two metals should be mixed so that the mixture is 15 times as heavy as water.
A 40
B 41
C 42
D 43
The load is too heavy ___ carry.
A too
B to be
C for
D to
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A Is at the maximum distance from CG of the rivet group
B Is at the minimum distance from CG of the rivet group
C Gives the maximum angle between the two forces Fa and Fm
D Gives the minimum angle between the two forces Fa and Fm
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm
If a truck can carry 10 to 16 boxed refrigerators, then what is the least number of refrigerators that 4 trucks can carry?
A 40
B 52
C 48
D 64
Fifty kg -- really a heavy weight to carry.
A is
B were
C are
D was
'Heavy water' is termed as 'heavy' because it is
A Denser than water
B An oxide of deuterium
C A heavy liquid
D An oxide of heavier isotope of oxygen
In a refinery petroleum crude is fractionated into gas fraction, light ends, intermediate distillates, heavy distillates, residues and by products. The group of products including gas oil, diesel oil and heavy fuel oil belongs to the fraction
A Heavy distillates
B Intermediate distillates
C Light ends
D Residues
The load factors for live load and dead load are taken respectively as
A 1.5 and 2.2
B 2.2 and 1.5
C 1.5 and 1.5
D 2.2 and 2.2
The simply supported beam 'A' of length '$$l$$' carries a central point load 'W'. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is 'W'. The ratio of maximum deflections between beams 'A' and 'B' is
A $$\frac{5}{8}$$
B $$\frac{8}{5}$$
C $$\frac{5}{4}$$
D $$\frac{4}{5}$$

Next steps