Bissoy.com
Doctors Medicines MCQs Q&A

In a certain code if 'M' denotes'÷', 'N' denotes '×', 'O' denotes '+' and 'P' denotes '-', then what will be the value of 16M4N3O5P3M3?

In a certain code if 'M' denotes'÷', 'N' denotes '×', 'O' denotes '+' and 'P' denotes '-', then what will be the value of 16M4N3O5P3M3? Correct Answer 16

Given expression: 16M4N3O5P3M3

After changing the signs,

16 ÷ 4 × 3 + 5 – 3 ÷ 3 

= 4 × 3 + 5 - 1 

= 12 + 5 - 1 

= 17 – 1 = 16

Related Questions

If ‘<’ denotes ‘-’, ‘+’ denotes ‘+’, ‘-’ denotes ‘=’ ‘=’ denotes ‘<’ and ‘x’ denotes ‘>’, then , '>' denotes '>' which of the following statement is true?
In the given Venn diagram, different animals are represented by different areas. 'A' denotes 'dogs', 'B' denotes 'cats', 'C' denotes 'fish', 'D' denotes 'mongooses, 'E' denotes 'rats', and 'F' denotes 'rabbits'. Which area represents the group of only dogs, fishes,  and mongooses?
In a certain code if 'M' denotes '÷', 'N' denotes '×', 'O' denotes '+' and 'P' denotes '-', then what will be the value of 27M3N5P6O9?
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
In a certain code ‘ner ler ser ker’ denotes ‘you can help me’, ‘ter ner ger’ denotes ‘you are determine and ‘mer der ger’ denotes ‘we are fine’. Which word denotes ‘determine in that code?
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
The figure shows: 1. Rectangle denotes male 2. Circle denotes urban 3. Square denotes educated 4. Tringle denotes civil servant The number which denotes Uneducated Urban Male:
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure