1 Answers
In electronics, potting is a process of filling a complete electronic assembly with a solid or gelatinous compound for high voltage assemblies by excluding gaseous phenomena such as corona discharge, for resistance to shock and vibration, and for the exclusion of water, moisture, or corrosive agents. When such materials are used only on the components, it is referred to as encapsulation.
Thermosetting plastics or silicone rubber gels are often used, though epoxy resins are also very common. When epoxy resins are used, low chloride grades are usually specified. Many sites recommend using a potting product to protect sensitive electronic components from impact, vibration, and loose wires.
In the potting process, an electronic assembly is placed inside a mold which is then filled with an insulating liquid compound that hardens, permanently protecting the assembly. The mold may be part of the finished article and may provide shielding or heat dissipating functions in addition to acting as a mold. When the mold is removed the potted assembly is described as cast.
As an alternative, many circuit board assembly houses coat assemblies with a layer of transparent conformal coating rather than potting. Conformal coating gives most of the benefits of potting, and is lighter and easier to inspect, test, and repair. Conformal coatings can be applied as liquid or condensed from a vapor phase.