Which device is employed to reduce the power factor in the case of the leading power factor in the transmission line 1. Synchronous condenser 2. SVC 3. Reactor?

Only (3)
Only (2)
(1), (2) and (3)
Only (1)

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Option 1 : Only (3)

Ferranti effect:

In the case of a no-load in the transmission line, the voltage at the receiving end becomes greater than the sending end. This condition is known as the Ferranti effect.
Under such cases, the power factor of the line becomes leading in nature.
In such cases, a synchronous reactor is connected to the receiving end.
It absorbs excess reactive power available in the line, thus decreasing the overvoltage condition.

5 views Answered 2022-09-04 04:29

Related Questions

Which semiconductor power device, out of the following, is not a current triggered device?

1 Answers 5 Views

Ram employs some men to do a piece of work in 100 days working 6 hours a day. But after working for 60 days they went on strike due to which the work was disrupted for 10 days and there was no work during strike. After that Ram employed 3 additional men to finish the work in time and he also increased the working hours by 1 hour. Find the initial number of men Ram employed?

1 Answers 4 Views

Consider a system consisting of a synchronous generator working at a lagging power factor, a synchronous motor working at an overexcited condition and a directly grid-connected induction generator. Consider capacitive VAr to be a source and inductive VAr to be a sink of reactive power. Which one of the following statements is TRUE?

1 Answers 4 Views

A 50 Hz synchronous generator is initially connected to a long lossless transmission line which is open circuited at the receiving end. With the field voltage held constant, the generator is disconnected from the transmission line. Which of the following may be said about the steady state terminal voltage and field current of the generator?

1 Answers 10 Views

A synchronous motor on load draw a current at a leading power factor angle ϕ. If the internal power factor angle which is the phase angle between the excitation emf and the current in the time phasor diagram is ψ. Then the air gap excitation mmf lags the armature mmf by?

1 Answers 40 Views

Engines are rated at specified conditions. Then which of the following statements are correct 1. Power developed increases as local temperature increases. 2. Power developed increases as local temperature decreases 3. Power developed is not dependent on local temperature. 4. Power developed increases as local atmospheric pressure increases. 5. Power developed increases as local atmospheric pressure decreases.?

1 Answers 5 Views

Which of the following statement is/are correct Lake Superior is the leading producer of high grade iron ore in North America. Gold is found mainly in Ontario, which has the largest gold mine in the world. Mexico is the leading producer of silver in the world. Select the correct code from below.?

1 Answers 5 Views

Consider the following advantages with respect of HVDC transmission: 1. Long distance transmission 2. Low cost of transmission 3. Higher efficiency Which of the above advantages are correct?

1 Answers 4 Views

Three statements are followed by three conclusions numbered I, II and III. Assuming the statements to be true even if they do not conform to real-world knowledge, decide which of the conclusions logically follows/follow from the statements. Statements: 1. All uncles are relatives. 2. Some relatives are neighbours. 3. All neighbours are employed. Conclusions: I. Some neighbours are uncles. II. Some uncles are employed. III. Some relatives are employed.?

1 Answers 5 Views

Which semiconductor power device out of the following, is not a current triggering device?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)