Which corner of the Word window has the zoom control?

Upper-left
Lower-right
Lower-left
Upper-right

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Option 2 : Lower-right

The Correct Answer is Lower-right.

The lower-right corner of the Word window has the zoom control.
For a closer look at your text, the zoom control enables you to zoom in.
The zoom control consists of a lever that you can shift left or right to zoom in or out to increase or decrease the zoom factor, you can press the + keys.
In the upper-left corner of the Word, the window has the File tab option.
The Lower-left corner of the Word, the window has the status bar.
In the Upper-right corner of the Word, the window has the Help section.

4 views Answered 2022-09-04 04:29

Related Questions

In the question below are given four statements followed by four conclusions numbered I, II, III and IV. You have to take the given statements to be true even if they seem to be at variance with commonly known facts. Read all the conclusions and then decide which of the given conclusions logically follows from the given statements disregarding commonly known facts. Statements: All Stone are Hammer. No Hammer is a Bell. Some Bell are Door. All Door are Window. Conclusions: I. Some Window are Stone. II. Some Window are Bell. III. No window is a stone. IV. Some Bell are Stone.?

1 Answers 5 Views

Consider the following statements regarding the slow start phase of the TCP congestion control algorithm. Note that cwnd stands for the TCP congestion window and MSS denotes the Maximum Segment Size. (i) The cwnd increases by 2 MSS on every successful acknowledgment. (ii) The cwnd approximately doubles on every successful acknowledgement. (iii) The cwnd increases by 1 MSS every round trip time. (iv) The cwnd approximately doubles every round trip time. Which one of the following is correct?

1 Answers 5 Views

The following are some events that occur after a device controller issues an interrupt while process L is under execution (P) The processor pushes the process status onto the control stack. (Q) The processor finishes the execution of the current instruction. (R) The processor executes the interrupt service routine. (S) The processor pops the process status of from the control stack. (T) The processor loads the new PC value based on the interrupt. Which one of the following is the correct order in which the events above occur?

1 Answers 5 Views

An open-loop control system is one in which the control action:?

1 Answers 4 Views

In making decisions about important questions, it is desirable to be able to distinguish between ‘strong’ arguments and ‘weak’ arguments. ‘Strong’ arguments are those which are both important and directly related to the question. ‘Weak’ arguments are those which are of minor importance and also may not be directly related to the question or may be related to a trivial aspect of the question. The question below is followed by two arguments numbered I and II. You have to decide which of the arguments a ‘strong’ argument is and which a ‘weak’ argument is. Statement: Should birth control be made a little more strict in India Arguments: I. Yes. Considering the excessive population growth and the problem of unemployment, it is the best option. II. No. There are people belonging to different cultures in India and some of them do not approve of birth control techniques.?

1 Answers 4 Views

Suppose two hosts use a TCP connection to transfer a large file. Which of the following statements is/are FALSE with respect to the TCP connection If the sequence number of a segment is m, then the sequence number of the subsequent segment is always m+1. If the estimated round trip time at any given point of time is t sec, the value of the retransmission timeout is always set to greater than or equal to t sec. The size of the advertised window never changes during the course of the TCP connection. The number of unacknowledged bytes at the sender is always less than or equal to the advertised window.?

1 Answers 6 Views

Assume that the bandwidth for a TCP connection is 1048560 bits /sec. Let α be the value of RTT in milliseconds (rounded off to the nearest integer) after which the TCP window scale option is needed. Let β be the maximum possible window size with window scale option. Then the values of α and β are?

1 Answers 6 Views

Select the option which has the same relation with the third word as the second word with the first word. Psychiatrist : Mental Health : : Dermatologist : ?

1 Answers 5 Views

Which are the three basic types of motion control systems in numerical control?

1 Answers 4 Views

Which of the following is NOT a valid option in the 'Paragraph' setting window in MS-Word 2016?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)