In session layer, during data transfer, the data stream responsible for the "control" purpose (i.e control of the session layer itself) is?

Regular Data
Typed data
Capability Data
Expedited Data

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

6 views Answered 2022-09-01 13:21

Related Questions

In convection heat transfer from hot flue gases to water tube, even though flow may be turbulent, a laminar flow region (boundary layer of film) exists close to the tube. The heat transfer through this film takes place by?

1 Answers 4 Views

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as?

1 Answers 7 Views

Assertion A : Airport capacity during IFR conditions is usually less than that during VFR conditions.Reason R: During clear weather condition (VFR), the aircrafts on final approach to runway can be spaced closer during poor visibility conditions.Select your answer based on the coding system given below:?

1 Answers 7 Views

Heat transfer by conduction results due to the transfer of free electrons, kinetic energy & vibrational energy from one molecule to another. Conduction heat transfer can not take place?

1 Answers 12 Views

The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as?

1 Answers 5 Views

Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the?

1 Answers 5 Views

If G = insoluble gas in gas stream and L = non-volatile solvent in liquid stream, then the slope of the operating line for the absorber is?

1 Answers 7 Views

The velocity, concentration and temperature boundary, for the boundary layer development on a flat plate during connective mass transfer will be same, if?

1 Answers 4 Views

The main purpose of control rod in a nuclear reactor is to control the?

1 Answers 5 Views

Routers operate at layer _____. LAN switches operate at layer _____. Ethernet hubs operate at layer _____. Word processing operates at layer _____.?

1 Answers 7 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)