To avoid the tearing off the plate of an edge, the margin (i.e., the minimum distance from the centre of the rivet hole to the nearest edge of the plate) should be equal to?

0.5 d
D
1.5 d
2.5 d

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

5 views Answered 2022-09-01 13:21

Related Questions

The centre of pressure for a vertically immersed surface lies at a distance equal to __________ the centre of gravity.?

1 Answers 4 Views

The lift off distance is the distance along the centre of the runway between the starting point and?

1 Answers 8 Views

For flow past a flat plate, if x is the distance along the plate in the direction of flow, the boundary layer thickness is proportional to?

1 Answers 5 Views

Introduction of slurry in a plate and frame filter press is done through a plate in each frame. The plate of this filter has a __________ surface.?

1 Answers 4 Views

Typical specifications for design stipulates the gain margin and phase margin to be respectively?

1 Answers 4 Views

Diameter of rivet hole (d, mm) and the plate thickness (t, mm) are related by Unwin's formula as?

1 Answers 5 Views

A high vapour velocity is required for high plate efficiency in a seive plate coloumn. The satisfactory value of operating vapor velocity for design purpose in seive plate column is about __________ percent of the flooding velocity.?

1 Answers 5 Views

The distance between the centre of a rivet hole to the nearest edge of the plate is called?

1 Answers 5 Views

Last year, there were three sections in a competitive exam. Out of them 33 students cleared the cut-off in Section A, 34 students cleared the cut-off in Section B and 32 students cleared the cut-off in Section C. 10 students cleared the cut-off in section A and section B, 9 cleared the cut-off in section B and section C and 8 cleared the cut-off in section A and section C. The number of students who cleared only one section was equal and was 21 for each section. How many students cleared all the three sections?

1 Answers 8 Views

In these questions, the first and last sentences of the passage are numbered 1 and 6. The rest of the passage is split into four parts and named P, Q, R, and S. These four parts are not given in their proper order. Read the sentences carefully and find out the correct sequence of the sentences. S1: A gentleman who lived alone always had two plates placed on the table at dinner time. P : One day just as he sat down to dine, the cat rushed into the room. Q : One plate was for himself and the other was for his cat. R : she dropped a mouse into her own plate and another into her master plate. S : He used to give the cat a piece of meat from his own plate. S6: In this way, the cat showed her gratitude to her master.?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)