An increase in the liquid resistance to interphase mass transfer and a resultant reduction in plate efficiency is caused by?

An increase in liquid viscosity
An increase in relatived volatility for rectification columns
Decrease in gas solubility for absorbers
All of the above

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

4 views Answered 2022-09-01 13:21

Related Questions

If average heat transfer co-efficient is ha and the local coefficient at the end of the plate is hl then in case of heat transfer to a fluid flowing over a flat plate, heated over its entire length?

1 Answers 5 Views

The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as?

1 Answers 5 Views

In an interphase heat transfer process, the equilibrium state corresponds to equality of temperature in the two phases, while the condition for equilibrium in an interphase mass transfer process is equality of?

1 Answers 7 Views

Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the?

1 Answers 5 Views

The surface renewal frequency in Danckwerts model of mass transfer is given by (KL: mass transfer co-efficient)?

1 Answers 4 Views

JD factor for mass transfer is a function of Reynolds number. Mass transfer by molecular diffusion from a single drop to surrounding still air is given by?

1 Answers 12 Views

In an interphase mass transfer process, the lesser the solubility of a given solute in a liquid, the higher are the chances that the transfer process will be?

1 Answers 6 Views

For experimental determination of mass transfer co-efficient by wetted wall tower, the mass transfer area is?

1 Answers 4 Views

A high vapour velocity is required for high plate efficiency in a seive plate coloumn. The satisfactory value of operating vapor velocity for design purpose in seive plate column is about __________ percent of the flooding velocity.?

1 Answers 5 Views

In these questions, the first and last sentences of the passage are numbered 1 and 6. The rest of the passage is split into four parts and named P, Q, R, and S. These four parts are not given in their proper order. Read the sentences carefully and find out the correct sequence of the sentences. S1: A gentleman who lived alone always had two plates placed on the table at dinner time. P : One day just as he sat down to dine, the cat rushed into the room. Q : One plate was for himself and the other was for his cat. R : she dropped a mouse into her own plate and another into her master plate. S : He used to give the cat a piece of meat from his own plate. S6: In this way, the cat showed her gratitude to her master.?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)