A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of?

2
20.8
20.2
20.5

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

4 views Answered 2022-09-01 13:21

Related Questions

In convection heat transfer from hot flue gases to water tube, even though flow may be turbulent, a laminar flow region (boundary layer of film) exists close to the tube. The heat transfer through this film takes place by?

1 Answers 4 Views

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as?

1 Answers 7 Views

A fluid is flowing inside the inner tube of a double pipe heat exchanger with diameter 'd'. For a fixed mass flow rate, the tube side heat transfer co-efficient for turbulent flow conditions is proportional to?

1 Answers 14 Views

For a laminar flow of fluid in a circular tube, 'h₁' is the convective heat transfer co-efficient at velocity 'V₁'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is?

1 Answers 8 Views

If h₁ = inner film co-efficient and /h₂ = outer film co-efficient, then the overall heat transfer co-efficient is?

1 Answers 10 Views

If all the conditions and dimensions are same, then the ratio of velocity through the tubes of a double pass heat exchanger to that through the single pass heat exchanger is?

1 Answers 4 Views

If a single tube pass heat exchanger is converted to two pass, then for the same flow rate, the pressure drop per unit length in tube side will?

1 Answers 5 Views

The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as?

1 Answers 5 Views

For turbulent flow in a tube, the heat transfer co-efficient is obtained from the Dittus-Boelter correlation. If the tube diameter is halved and the flow rate is doubled, then the heat transfer co-efficient will change by a factor of?

1 Answers 6 Views

Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)