Hot extrusion of aluminium is done in the temperature range of __________ °C.?

550-600
450-500
350-400
250-300

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

4 views Answered 2022-09-01 13:21

Related Questions

Aluminium bronze contains aluminium and copper in the ratio of?

1 Answers 5 Views

The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity.?

1 Answers 4 Views

Temperature of hot gases flowing in a pipe is measured by a thermocouple inserted in the thermal well. The thermal well made of __________ will facilitate the most accurate measurement of the temperature.?

1 Answers 8 Views

Hot extrusion process is not used for making?

1 Answers 4 Views

The expression for the work done for a reversible polytropic process can be used to obtain the expression for work done for all processes, except reversible __________ process.?

1 Answers 4 Views

In the converter of the contact process for the manufacture of H₂SO₄ the equilibrium conversion of SO₂ __________ (i) __________ with increase in temperature and __________ (ii) __________ with increase in the mole ratio of SO₂ to air.?

1 Answers 6 Views

In a parallel flow heat exchanger, if the outlet temperature of hot and cold fluids are the same, then the log mean temperature difference (LMTD) is?

1 Answers 5 Views

If the thermal conductivity of a wall material is independent of temperature, the steady state temperature distribution in the very large thin plane wall having steady, uniform surface temperature follows __________ law.?

1 Answers 20 Views

In case of parallel flow heat exchanger, the lowest temperature theoretically attainable by the hot fluid is __________ the outlet temperature of the cold fluid.?

1 Answers 5 Views

Large process vessels operating under extreme temperature and pressure conditions are normally clad/ lined with materials like stainless steel, aluminium, nickel & its alloys, copper & its alloys and titanium. The cladding thickness is generally about __________ percent of the total thickness.?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)