Minimum composite sleeper index pres-cried on Indian Railways for a track sleeper is?

552
783
1352
1455

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

4 views Answered 2022-09-01 13:21

Related Questions

For a two stage compressor, if index of compression for higher stage is greater than index of compression for lower stage, then the optimum pressure as compared to ideal case will?

1 Answers 7 Views

Assertion A : For identical strength, a composite cement-lime mortar is preferred over cement mortar.Reason R : Composite cement-lime mortar has higher drying shrinkage than cement mortar.Select your answer based on the codes given below. Codes:?

1 Answers 5 Views

According to the Snell's law if an electromagnetic wave is incident in a medium (refractive index n₁) on another medium (refractive index m₂);?

1 Answers 9 Views

For the purpose of track maintenance, the number of turn out equivalent to one track km are?

1 Answers 6 Views

Standard size of wooden sleeper for Broad Gauge track is?

1 Answers 4 Views

The formation width for a single line meter gauge track in embankment as adopted on Indian Railways is?

1 Answers 5 Views

The formation width for a double line Broad Gauge track in cutting (excluding drains) as adopted on Indian Railways is?

1 Answers 4 Views

If altitude bubble is provided both on index frame as well as on telescope of a theodolite, then the instrument is levelled with reference toi) altitude bubble on index frameii) altitude bubble on index frame if it is to be used as a leveliii) altitude bubble on telescopeiv) altitude bubble on telescope if it is to be used as a level The correct answer is?

1 Answers 6 Views

Chemical engineering plant cost index is used for finding the present cost of a particular chemical plant, if the cost of similar plant at some time in the past is known. The present cost of the plant = original cost x (index value/(index value at original cost was obtained)The most major component of this cost index is?

1 Answers 6 Views

The value of work index does not change materially from one equipment to another. If the value of work index determined for close circuit grinding is Wi, then the same for open circuit grinding will be?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)