In the cross-section of a weld, throat is the?

minimum dimension
average dimension
maximum dimension
none of the above

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

5 views Answered 2022-09-01 13:21

Related Questions

A double fillet welded joint with parallel fillet weld of length '$$l$$' and leg 's' is subjected to a tensile force 'P'. Assuming uniform stress distribution, the shear stress in the weld is given by?

1 Answers 5 Views

In a butt welded joint, the size of weld is __________ the throat of weld.?

1 Answers 5 Views

In a transverse fillet welded joint, the size of weld is __________ the throat of weld.?

1 Answers 4 Views

In order to avoid tendency of separation at throat in a Venturimeter, the ratio of the diameter at throat to the diameter of pipe should be?

1 Answers 5 Views

The ratio of the area of cross-section of a circular section to the area of its core, is?

1 Answers 4 Views

If D is the depth of water upstream of the throat above its sill, B is the width of the throat, to achieve critical flow in an open venturi flume, the theoretical maximum flow Q, is?

1 Answers 6 Views

To determine the discharge at a section in a stream from its rating curve, the required data are i) slope of water surface at the section ii) stage at the section iii) current meter readings at the section The correct answer is?

1 Answers 4 Views

If straight sides of a triangular section of a lined canal with circular bottom of radius R, make an angle θ with horizontal, the area of its cross-section, is?

1 Answers 5 Views

In the cross-section method of indirect contouring, the spacing of cross-sections depends uponi) contour intervalii) scale of planiii) characteristics of groundThe correct answer is?

1 Answers 5 Views

A pipe is generally made of circular cross-section, because a circular cross-section has the?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)