Lapped splices in tensile reinforcement are generally not used for bars of size larger than?

18 mm diameter
24 mm diameter
30 mm diameter
36 mm diameter

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

4 views Answered 2022-09-01 13:21

Related Questions

In working stress design, permissible bond stress in the case of deformed bars is more than that in plain bars by?

1 Answers 7 Views

In a tensile test on mild steel specimen, the breaking stress as compared to ultimate tensile stress is?

1 Answers 6 Views

If the main reinforcement of the slab is parallel to a T-beam, the transverse reinforcement at mid span of the slab is provided at least __________ of main reinforcement.?

1 Answers 6 Views

Minimum spacing between horizontal parallel reinforcement of the same size should not be less than?

1 Answers 4 Views

The amount of reinforcement for main bars in a slab, is based upon?

1 Answers 4 Views

The length of lap in tension reinforcement should not be less than the bar diameter × (actual tension / four times the permissible average bond stress) if it is more than?

1 Answers 5 Views

Steel bars are generally connected together to get greater length than the standard length by providing?

1 Answers 4 Views

Though the effective depth of a T-beam is the distance between the top compression edge to the centre of the tensile reinforcement, for heavy loads, it is taken as?

1 Answers 5 Views

Compared to mild steel, cast iron has (i) High compressive strength (ii) High tensile strength (iii) Low compressive strength (iv) Low tensile strength?

1 Answers 5 Views

A cylinderical rod subjected to a tensile strain within the elastic limit undergoes a volume change. If the volume strain is equal to half the tensile strain, then the Poisson's ratio of the rod is?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)