In the slope deflection equations, the deformations are considered to be caused byi) bending momentii) shear forceiii) axial forceThe correct answer is?

only (i)
(i)and(ii)
(ii) and (iii)
(i), (ii) and (iii)

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

4 views Answered 2022-09-01 13:21

Related Questions

In a ring beam subjected to uniformly distributed loadi) shear force at mid span is zeroii) shear force at mid span is maximumiii) torsion at mid span is zeroiv) torsion at mid span is maximum The correct answer is?

1 Answers 6 Views

The depth of footing for an isolated column is governed byi) maximum bending momentii) shear forceiii) punching shear The correct answer is?

1 Answers 4 Views

A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is $$\tau $$. The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be?

1 Answers 5 Views

The bending moment ‘M’ and a torque ‘T’ is applied on a solid circular shaft. If the maximum bending stress equals to maximum shear stress developed, then ‘M’ is equal to?

1 Answers 5 Views

The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called?

1 Answers 5 Views

A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to?

1 Answers 4 Views

In a simple bending theory, one of the assumptions is that the plane sections before bending remain plane after bending. This assumption means that?

1 Answers 4 Views

A shaft is subjected to bending moment M and a torque T simultaneously. The ratio of the maximum bending stress to maximum shear stress developed in the shaft, is?

1 Answers 5 Views

A tri-axial shear test is preferred to direct shear test, because?

1 Answers 4 Views

The uplift pressure on a dam can be controlled byi) constructing cutoff under upstream faceii) constructing drainage channels bet-ween the dam and its foundationiii) by pressure grouting in foundationThe corret answer is?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)