In time study, the rating factor is applied to determine?

Standard time of a job
Merit rating of the worker
Fixation of incentive rate
Normal time of a worker

LohaHridoy

8 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

In time study, the rating factor is applied to determine Fixation of incentive rate

8 views Answered 2022-09-01 13:21

Related Questions

A synchronous motor installed at the receiving end substation operates with such an excitation that it takes power at lagging power factor. Now if the applied voltage of the synchronous motor goes down, the power factor of the synchronous motor will?

1 Answers 9 Views

For given applied voltage, with the increase in frequency of the applied voltage?

1 Answers 4 Views

The objective of time study is to determine the time required to complete a job by?

1 Answers 4 Views

Time study is carried out to determine the time required to complete job by?

1 Answers 4 Views

Abbreviated work factor data is applied for?

1 Answers 4 Views

The ratio of the stresses produced by a suddenly applied load and by a gradually applied load on a bar, is?

1 Answers 4 Views

If Q is load factor, S is shape factor and F is factor of safety in elastic design, the following:?

1 Answers 8 Views

To determine the discharge at a section in a stream from its rating curve, the required data are i) slope of water surface at the section ii) stage at the section iii) current meter readings at the section The correct answer is?

1 Answers 4 Views

The LMTD correction factor (FT) is applied in __________ heat exchangers.?

1 Answers 15 Views

Factor of safety (i.e., overdesign factor) in heat transfer equipments is about __________ percent more than the actual/theoretical design factor.?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)