The reconditioning process used to give cylinder bore surfaces a crosshatch pattern, is known as?

Honing
Porous plating
Boring
Shot peening

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

The reconditioning process used to give cylinder bore surfaces a crosshatch pattern, is known as Honing

4 views Answered 2022-09-01 13:21

Related Questions

If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be?

1 Answers 5 Views

If p₁ is the pressure of air entering the L.P, cylinder and p₃ is the pressure of air leaving the H.P. cylinder, then the ratio of cylinder diameters for a single acting, two stage reciprocating compressor with complete intercooling is given by?

1 Answers 4 Views

In an internal combustion engine, the process of removing the burnt gases from the combustion chamber of the engine cylinder is known as?

1 Answers 4 Views

If one cylinder of a diesel engine receives more fuel than the others, then for that cylinder the?

1 Answers 5 Views

The process of removing the burnt gases from the engine cylinder by the fresh charge coming into the engine cylinder from the crankcase, is known as?

1 Answers 5 Views

In aluminium cylinder blocks, the cylinder liners are made of?

1 Answers 4 Views

The process of supplying the intake air to the engine cylinder at a pressure greater than the pressure of the surrounding atmosphere is known as?

1 Answers 5 Views

The main merit of a multi cylinder type cylinder sleeve is?

1 Answers 7 Views

The ratio of the speed of a rolling cylinder to the speed of sliding cylinder is?

1 Answers 4 Views

Solvay process as compared to dual process (i.e. modified Solvay process)?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)