More than one stage will be preferred for reciprocating compressor if the delivery pressure is more than?

2 kg/cm²
6 kg/cm²
10 kg/cm²
14.7 kg/cm²

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

More than one stage will be preferred for reciprocating compressor if the delivery pressure is more than 2 kg/cm²

6 views Answered 2022-09-01 13:21

Related Questions

In a single acting reciprocating compressor, the suction, compression and delivery of air takes place in ________ of the piston.?

1 Answers 5 Views

The minimum work required for a three stage reciprocating air compressor is ________ the work required for each stage.?

1 Answers 7 Views

In a high pressure compressor, the delivery pressure is?

1 Answers 6 Views

For a two stage compressor, if index of compression for higher stage is greater than index of compression for lower stage, then the optimum pressure as compared to ideal case will?

1 Answers 7 Views

If p₁ is the pressure of air entering the L.P, cylinder and p₃ is the pressure of air leaving the H.P. cylinder, then the ratio of cylinder diameters for a single acting, two stage reciprocating compressor with complete intercooling is given by?

1 Answers 4 Views

In a single stage, single acting reciprocating air compressor, without clearance, the work-done on the air during isentropic compression is ________ the heat required to raise the temperature of air from T₁ to T₂ at a constant pressure.?

1 Answers 6 Views

For a two stage reciprocating compressor, compression from p₁ to p₃ is with perfect intercooling and no pressure losses. If compression in both the cylinders follows the same polytropic process and the atmospheric pressure is pa, then the intermediate pressure p₂ is given by?

1 Answers 6 Views

In an axial flow compressor, the ratio of pressure in the rotor blades to the pressure rise in the compressor in one stage is known as?

1 Answers 5 Views

The maximum delivery pressure of a reciprocating compressor may be about __________ kg/cm².?

1 Answers 4 Views

The variable required to be known in correlations used for estimating the horse power of a centrifugal gas compressor and hence its cost are P. Inlet pressure Q. Compressor rpm R. Delivery pressure S. Volumetric flow rate at inlet.?

1 Answers 9 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)