The ratio of the increase in pressure in rotor blades to total increase in pressure in the stage is called?

Pressure ratio
Pressure coefficient
Degree of reaction
Slip factor

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

The ratio of the increase in pressure in rotor blades to total increase in pressure in the stage is called degree of reaction

4 views Answered 2022-09-01 13:21

Related Questions

For a two stage compressor, if index of compression for higher stage is greater than index of compression for lower stage, then the optimum pressure as compared to ideal case will?

1 Answers 7 Views

If p₁ is the pressure of air entering the L.P, cylinder and p₃ is the pressure of air leaving the H.P. cylinder, then the ratio of cylinder diameters for a single acting, two stage reciprocating compressor with complete intercooling is given by?

1 Answers 4 Views

For a two stage reciprocating compressor, compression from p₁ to p₃ is with perfect intercooling and no pressure losses. If compression in both the cylinders follows the same polytropic process and the atmospheric pressure is pa, then the intermediate pressure p₂ is given by?

1 Answers 6 Views

In an axial flow compressor, the ratio of pressure in the rotor blades to the pressure rise in the compressor in one stage is known as?

1 Answers 5 Views

The ratio of the workdone on the blades to the energy supplied to the blades, is called?

1 Answers 6 Views

The ratio of the work-done on the blades per kg of steam to the total energy supplied per stage per kg of steam is called?

1 Answers 9 Views

By increasing the rise of lock-gates, (i) The length of the lock gate will increase (ii) Transverse stress due to water pressure on the gate will increase (iii) Compressive force on the gate will increase?

1 Answers 5 Views

In case of a centrifugal pump, the ratio of total delivered pressure to pressure developed with the impeller is called the __________ efficiency.?

1 Answers 4 Views

The blades of a centrifugal impeller are said to be curved forward, if the __________ of the motion of impeller blades.?

1 Answers 4 Views

Pressure maintained in the high pressure primary tower of a three stage crude oil distillation system is about __________ kg/cm² .?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)