In a heat exchanger with one fluid evaporating or condensing, the surface area required is least in?

Parallel flow
Counter flow
Cross flow
All of these

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

In a heat exchanger with one fluid evaporating or condensing, the surface area required is least in -Parallel flow - Counter flow - Cross flow

6 views Answered 2022-09-01 13:21

Related Questions

LMTD in case of counter flow heat exchanger as compared to parallel flow heat exchanger is?

1 Answers 4 Views

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as?

1 Answers 7 Views

The condensing pressure due to the presence of non-condensable gases, as compared to that actually required for condensing temperatures without non-condensable gases,?

1 Answers 7 Views

LMTD for evaporators & condensers for a given terminal parameters & set of conditions for counterflow is equal to that for parallel flow. In such heat exchangers, with one of the fluids condensing or evaporating, the surface area required is the least in the __________ flow.?

1 Answers 4 Views

In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat exchanger.?

1 Answers 4 Views

In a heat exchanger, the rate of heat transfer from the hot fluid to the cold fluid?

1 Answers 4 Views

A concentric double pipe heat exchanger as compared to the shell and tube heat exchanger for the same heat load requires?

1 Answers 4 Views

Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the?

1 Answers 5 Views

For shell and tube heat exchanger, with increasing heat transfer area, the purchased cost per unit heat transfer area?

1 Answers 5 Views

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)