The Press-Pull tool will ________ the face of a solid model in the direction it faces.?

Taper
Extrude
Spiral
None of the above

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

4 views Answered 2022-09-01 13:21

Related Questions

J.J. Thomson’s proposed model of atom is generally called ________ model.?

1 Answers 4 Views

The velocity of tool along the tool face is known as?

1 Answers 6 Views

The angle made by the face of the tool and the plane parallel to the base of cutting tool is called?

1 Answers 6 Views

In the design of a front counterfort in a counterfort retaining wall, the main reinforcement is provided oni) bottom face near counterfortii) top face near counterfortiii) bottom face near centre of spaniv) top face near centre of span The correct answer is?

1 Answers 6 Views

The main reinforcement in the toe of a T- shaped R C. retaining wall is provided oni) top face parallel to the wallii) top face perpendicular to the walliii) bottom face paralleUo the walliv) bottom face perpendicular to the wallThe correct answer is?

1 Answers 4 Views

In a counterfort retaining wall, the main reinforcement is provided on thei) bottom face in front counterfortii) inclined face in front counterfortiii) bottom face in back counterfortiv) inclined face in back counterEortThe correct answer is?

1 Answers 4 Views

In case of antenna the ratio of the power radiated in the desired direction to the power radiated in the opposite direction is known as?

1 Answers 4 Views

The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.?

1 Answers 5 Views

In order to create one solid model from two or more separate solid shapes the drafter will need to position them and then ________.?

1 Answers 4 Views

The ________ tool on the Dimension tool bar places the length of an arch on a drawing.?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)