A cylinder can be created by drawing a rectangular shape then the ________ tool.?

Revolve
Sweep
Extrude
None of the above

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

5 views Answered 2022-09-01 13:21

Related Questions

The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.?

1 Answers 5 Views

A line with a tapering width can be easily created by using the ________ tool.?

1 Answers 4 Views

In order to set drawing limits for a 'C' size architectural drawing the drafter should set the limits to ________.?

1 Answers 8 Views

The ________ tool on the Dimension tool bar places the length of an arch on a drawing.?

1 Answers 4 Views

In developing a multi-view drawing, the drafter can use a ________ line to help locate the top and right side views.?

1 Answers 6 Views

This type of drawing is created to calculate areas, locate property lines, and locate building projects and facilities:?

1 Answers 5 Views

The Offset tool should only be used for placing _________ in an isometric drawing.?

1 Answers 5 Views

In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.?

1 Answers 4 Views

If p₁ is the pressure of air entering the L.P, cylinder and p₃ is the pressure of air leaving the H.P. cylinder, then the ratio of cylinder diameters for a single acting, two stage reciprocating compressor with complete intercooling is given by?

1 Answers 4 Views

If one cylinder of a diesel engine receives more fuel than the others, then for that cylinder the?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)