In riveted boiler joints, all stresses, shearing, bearing and tensile are based on the?

Size of rivet
Size of the drilled or reamed hole
Average of size of rivet and hole
Smaller of the two

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

6 views Answered 2022-09-01 13:21

Related Questions

The shearing stresses in the inner face as compared to outer face of the wire in a heavy close coiled spring is?

1 Answers 4 Views

If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to?

1 Answers 5 Views

If p = bearing pressure on projected bearing area, Z = absolute viscosity of lubricant and N = speed of journal, then the bearing characteristic number is given by?

1 Answers 5 Views

In calculating the strength of a riveted joint in tearing, shearing and crushing, the?

1 Answers 4 Views

The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called?

1 Answers 5 Views

These types of pipes are generally connected with bell and spigot joints or flanged joints:?

1 Answers 8 Views

The drive-shafts are connected to the differential and wheel hubs through universal joints because the universal joints?

1 Answers 5 Views

A singly reinforced beam has breadth b, effective depth d, depth of neutral axis n and critical neutral axis n. If fc and ft are permissible compressive and tensile stresses, the moment to resistance of the beam, is?

1 Answers 7 Views

Bending compressive and tensile stresses respectively are calculated based on?

1 Answers 4 Views

The type of bearing plate used in all joints and on curves to give better bearing area to the rails is?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)