In a cam drive with uniform velocity follower, the sharp corners of the displacement diagram are rounded off at the beginning and at the end of each stroke. This is done?

Because of difficulty in manufacturing cam profile
Because of loose contact of follower with cam surface
In order to have acceleration in beginning and retardation at the end of stroke within the finite limits
Because the uniform velocity motion is a partial parabolic motion

LohaHridoy

7 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

7 views Answered 2022-09-01 13:21

Related Questions

The vector sum of cutting velocity and chip velocity is __________ shear velocity.?

1 Answers 13 Views

The difference between CAD and CAM is that CAD software is directed at product design while CAM software is:?

1 Answers 4 Views

In a circular arc cam with roller follower, the acceleration in any position of the lift will depend only upon?

1 Answers 6 Views

The cam and follower is an example of?

1 Answers 5 Views

For S.H.M. cam, the acceleration of the follower at the ends of the stroke and aimed stroke respectively, is?

1 Answers 5 Views

The pressure angle of a cam is the angle between the direction of the follower motion and a normal to the?

1 Answers 4 Views

In a radial cam, the follower moves?

1 Answers 4 Views

For low and moderate speed engines, the cam follower should move with?

1 Answers 5 Views

A jet of water is striking at the centre of a curved vane moving with a uniform velocity in the direction of jet. For the maximum efficiency, the vane velocity is ________ of the jet velocity?

1 Answers 14 Views

If a particle moves with a uniform angular velocity ‘ω’ radians/sec along the circumference of a circle of radius ‘r’, the equation for the velocity of the particle, is?

1 Answers 8 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)