If a periodic pulse waveform has a pulse width and the time between pulses each equal to or greater than five time constants, the capacitor will?

Partially charge and fully discharge during each period of the input waveform
Fully charge and partially discharge during each period of the input waveform
Fully charge and fully discharge during each period of the input waveform
Partially charge and partially discharge during each period of the input waveform

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

4 views Answered 2022-09-01 13:21

Related Questions

The rise time of a pulse waveform is the time required for the voltage to rise:?

1 Answers 4 Views

The rising and falling edges of a pulse waveform contain the higher frequency component.?

1 Answers 5 Views

A dc component is the peak value of a pulse waveform.?

1 Answers 4 Views

The flat portions of a pulse waveform contain low-frequency components.?

1 Answers 5 Views

Five time constants are required for a capacitor to charge fully or discharge fully.?

1 Answers 6 Views

A capacitor and a resistor are connected in series to a sine wave generator. The frequency is set so that the capacitive reactance is equal to the resistance and, thus, an equal amount of voltage appears across each component. If the frequency is increased?

1 Answers 7 Views

Duty cycle is the characteristic of a pulse waveform that indicates the high time versus the low time.?

1 Answers 4 Views

The rectangular beam 'A' has length ‘l’, width ‘b’ and depth ‘d’. Another beam 'B' has the same length and depth but width is double that of 'A'. The elastic strength of beam 'B' will be _________ as compared to beam ‘A’.?

1 Answers 17 Views

The rectangular beam 'A ' has length l, width b and depth d. Another beam 'B' has the same width and depth but length is double that of 'A'. The elastic strength of beam 'B' will be __________ as compared to beam A.?

1 Answers 11 Views

If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)