Low pressure Zeigler process of polythene manufacture?

Employs a pressure of 30 kgf/cm²
Achieves an yield of 95-98% based on ethylene
Produces very low density polythene
Does not use any catalyst for polymerisation

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

5 views Answered 2022-09-01 13:21

Related Questions

A low-area storm with high winds rotating about a centre of low atmospheric pressure substitution?

1 Answers 4 Views

Electric process as compared to wet process (for the manufacture of phosphoric acid)?

1 Answers 5 Views

In the manufacture of H₃ PO₄ (ortho), ; strong H₂ SO₄ leaching wet process as compared to electric furnace process?

1 Answers 4 Views

Zeigler - Natta catalyst (AlR₃ - AlCl₃) is used in the polymerisation of?

1 Answers 4 Views

Low density polythene as compared to high density polythene is?

1 Answers 4 Views

Density of low density polythene is about __________ gm/c.c.?

1 Answers 4 Views

Typical solvent polymerisation reaction conditions for the production of high density polythene by Zeigler process is?

1 Answers 4 Views

Catalyst used in the production of high density polythene by low pressure Ziegler process is?

1 Answers 4 Views

With an RS latch a high S and low R sets the output to _____ ; a low S and a high R _____ the output to low.?

1 Answers 6 Views

For a two stage reciprocating compressor, compression from p₁ to p₃ is with perfect intercooling and no pressure losses. If compression in both the cylinders follows the same polytropic process and the atmospheric pressure is pa, then the intermediate pressure p₂ is given by?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)