In abrasive jet machining, as the distance between the nozzle tip and the work surface increases, the material removal rate?

Increases continuously
Decreases continuously
Decreases becomes stable and then increases
Increases, becomes stable and then decreases

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

6 views Answered 2022-09-01 13:21

Related Questions

The abrasive slurry used in ultrasonic machining contains fine particles of?

1 Answers 4 Views

In machining metals, chips break due to __________ of work material.?

1 Answers 4 Views

A jet of water is striking at the centre of a curved vane moving with a uniform velocity in the direction of jet. For the maximum efficiency, the vane velocity is ________ of the jet velocity?

1 Answers 14 Views

A nozzle is said to be a divergent nozzle?

1 Answers 5 Views

The draught produced by a steam jet issuing from a nozzle placed in the chimney is called?

1 Answers 8 Views

A nozzle is said to be a convergent nozzle?

1 Answers 4 Views

The draught produced by a steam jet issuing from a nozzle placed in the ash-pit under the fire grate of the furnace is called?

1 Answers 4 Views

The discharge of steam in a convergent-divergent nozzle __________ after the throat (i.e. in the divergent portion of the nozzle)?

1 Answers 5 Views

As compared to rapid sand filters, slow sand filters give (i) Slower filtration rate (ii) Higher filtration rate (iii) Lesser efficiency in removal of bacteria (iv) Higher efficiency in removal of bacteria The correct answer is?

1 Answers 4 Views

Cleaning is done by (i) Scraping and removal in filters slow sand (ii) Back washing in slow sand filters (iii) Scraping and removal in filters rapid sand (iv) Back washing in rapid sand filtersThe correct answer is?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)