The increase in depth of cut and feed rate _________ surface finish.?

Improves
Deteriorates
Does not effect
None of these

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

the surface roughness is directly influenced by the spindle speed and feed rate. It is observed that the surface roughness increases with increased feed rate and is higher at lower speeds and vice versa for all feed rates.

4 views Answered 2022-09-01 13:21

Related Questions

In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be?

1 Answers 5 Views

_________ detects the satellite signal relayed from the feed and converts it to an electric current, amplifies and lower its frequency.?

1 Answers 7 Views

In a regenerative feed heating cycle, the optimum value of the fraction of steam extracted for feed heating?

1 Answers 5 Views

The rectangular beam 'A' has length ‘l’, width ‘b’ and depth ‘d’. Another beam 'B' has the same length and depth but width is double that of 'A'. The elastic strength of beam 'B' will be _________ as compared to beam ‘A’.?

1 Answers 17 Views

A simply supported beam 'A' of length l, breadth b, and depth d carries a central point load W. Another beam 'B' has the same length and depth but its breadth is doubled. The deflection of beam 'B' will be __________ as compared to beam 'A'.?

1 Answers 7 Views

The depth of center of pressure of an immersed surface, inclined at an angle 'θ' with the liquid surface lies at a distance equal to __________ the center of gravity.?

1 Answers 7 Views

The intensity of pressure on an immersed surface __________ with the increase in depth.?

1 Answers 5 Views

The process of draining steam from the turbine, at certain points during its expansion and using this steam for heating the feed water in feed water heaters and then supplying it to the boiler is known as?

1 Answers 8 Views

A singly reinforced beam has breadth b, effective depth d, depth of neutral axis n and critical neutral axis n. If fc and ft are permissible compressive and tensile stresses, the moment to resistance of the beam, is?

1 Answers 7 Views

In a doubly-reinforced beam if ‘c’ and ‘t’ are stresses in concrete and tension reinforcement, ‘d’ is the effective depth and ‘n’ is depth of critical neutral axis, the following relationship holds good?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)