In determining the various forces on the chip, Merchant assumed that the?

Question

In determining the various forces on the chip, Merchant assumed that the?

Cutting edge of the tool is sharp and it does not make any flank contact with the workpiece
Only continuous chip without built-up-edge is produced
Cutting velocity remains constant
All of the above

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

Related Questions

Three forces acting on a rigid body are represented in magnitude, direction and line of action by the three sides of a triangle taken in order. The forces are equivalent to a couple whose moment is equal to?

1 Answers 7 Views

Concurrent forces are those forces whose lines of action?

1 Answers 4 Views

In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be?

1 Answers 5 Views

In designing a key, it is assumed that the distribution of forces along the length of key?

1 Answers 4 Views

If the resultant of two equal forces has the same magnitude as either of the forces, then the angle between the two forces is?

1 Answers 4 Views

A liquid would wet the solid, if adhesion forces as compared to cohesion forces are?

1 Answers 4 Views

H V are the algebraic sums of the forces resolved horizontally and vertically respectively, M is the algebraic sum of the moments of forces about any point, for the equilibrium of the body acted upon?

1 Answers 5 Views

Parallelogram Law of Forces states, "if two forces acting simultaneously on a particle be represented in magnitude and direction by two adjacent sides of a parallelogram, their resultant may be represented in magnitude and direction by?

1 Answers 5 Views

If two forces are in equilibrium, then the forces must (i) Be equal in magnitude (ii) Be opposite in sense (iii) Act along the same line?

1 Answers 5 Views

The graphical method of determining the forces in the members of a truss is based on?

1 Answers 4 Views

AhmedNazir · Accepted Answer · 2022-09-01T13:21:41+06:00

AhmedNazir

Answer: Option 4

Assumption in Merchant's Force Circle: - The chip is considered in equilibrium under action of two equal and opposite collinear forces. -The stress is maximum at the shear plane and it remains constant. - The shear takes place in a direction in which the energy required for shearing is minimum

4 views Answered 2022-09-01 13:21