Melt spinning of polymers involves the forcing of polymer melt through spinnerettes (fine holes) into an atmosphere kept at a temperature lower than the melting point of the polymer, which causes the fine diameter polymer melt to harden into filaments. Melt spinning is not used in case of the __________ fibres.?

Acrylic
Polyester
Nylon 6:6
Polypropylene

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

Let'

5 views Answered 2022-09-01 13:21

Related Questions

An intrinsic semiconductor has some holes in it at room temperature. What causes these holes?

1 Answers 9 Views

In case of dry spinning of polymers, the polymer solution in a volatile solvent is forced through the spinnerates into a warm air chamber, where the solvent evaporates leaving behind the polymer in the filament form. Dry spinning is used for __________ fibres.?

1 Answers 5 Views

Direction : Two statements I and II are given. These statement may be either independent causes or may be effects of independent causes or a common cause. One of these statements may be the effect of the other statements. Read both the statements and decide which of the following answer choice correctly depicts the relationship between these two statements. Mark answer : I. The government has recently fixed the fees for professional courses offered by the unaided institutions which are much lower than the fees charged last year. II. The parents of the aspiring students launched a severe agitation last year protesting against the high fees charged by the unaided institutions.?

1 Answers 6 Views

Hot dipping process is used for coating a low melting point metal (e.g. Pb, Sn, Zn) on iron, steel & copper having relatively higher melting points. Which of the following is not a hot dipping process?

1 Answers 4 Views

There are five concentric layers within the atmosphere which is differentiated on the basis of temperature. The atmospheric layer which lies close to the earth's surface in which human being along with other organisms live is called troposphere. The rate at which air temperature in the troposphere gradually decreases with height is about __________ °C/km.?

1 Answers 4 Views

If the solubilities of different components (in a liquid-liquid extraction system) increase with rise in temperature, then the temperature above which they dissolve completely is known as the critical solution temperature (CST or consolute temperature). If solubilities increase with decrease in temperature, then CST is the temperature below which they dissolve completely. If a binary system has no critical solution temperature, it implies that?

1 Answers 6 Views

Identify the group in which all the polymers mentioned can be used to make fibres.?

1 Answers 5 Views

Cross linked polymers formed from bi-and trifuctional groups in which cross-linkage in three dimensions via few chemical bonding across linear chains occur imparts to the polymer __________ properties.?

1 Answers 6 Views

Acrilan fibres used for making cloth, carpet & blankets, which is a hard, horny & high melting polymeric material is nothing but?

1 Answers 4 Views

Which of the following are true with regard to temperature control of the atmosphere of a given place I. The major temperature contrasts on earth's surface are between land masses and oceans II. During night, the water surface cools more rapidly than the land surface III. Temperature generally decreases with latitude on either side of the equator IV. Temperature rises to a maximum during summer and falls to a minimum during winter?

1 Answers 8 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)