Which of the following mixtures does not form an azeotrope at atmosheric pressure?

Water-alcohol
Methyl alcohol-acetone
Butyl acetate-water
None of these

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

Let'

4 views Answered 2022-09-01 13:21

Related Questions

At what percentage (by volume) of alcohol composition, it forms an azeotrope with water?

1 Answers 5 Views

According to Dalton's law of partial pressures, (where pb = Barometric pressure, pa = Partial pressure of dry air, and pv = Partial pressure of water vapour)?

1 Answers 4 Views

The inter-cooler pressure, for minimum work required, for a two stage reciprocating air compressor, is given by (where p₁ = Intake pressure of air, p₂ = Inter-cooler pressure, and p₃ = Delivery pressure of air)?

1 Answers 8 Views

For maximum work, the reheating should be done to an intermediate pressure of (Where p₁ = Maximum pressure, and p₂ = Minimum pressure)?

1 Answers 5 Views

If p₁, is the pressure of air entering the L.P. cylinder and p₂ is the pressure of air leaving the L.P. cylinder (or inter-cooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D₁ = Dia. of L.P. cylinder, and D₂ = Dia. of H.P. cylinder)?

1 Answers 6 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.?

1 Answers 4 Views

The critical pressure ratio is given by (where p₁ = Initial pressure of steam, and p₂ = Pressure of steam at throat or critical pressure)?

1 Answers 4 Views

The location of centre of pressure, which defines the point of application of the total pressure force on the surface, can be calculated by applying the principle of moments according to which "sum of the moment of the resultant force about an axis is equal to the sum of the components about the same axis". The centre of pressure of a rectangular surface (of width 'w') immersed vertically in a static mass of fluid is at a depth of(where, y = depth of the liquid)?

1 Answers 6 Views

Which of the following binary systems is an example of a maximum boiling azeotrope?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)