In which of the waste heat recovery equipment, the flow of flue gas and air is alternately reversed after a fixed interval of time?

Recuperator
Regenerator
Waste heat boiler
None of these

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

4 views Answered 2022-09-01 13:21

Related Questions

Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?

1 Answers 4 Views

The sensible heat factor during the heating and humidification process is given by (where h₁ = Enthalpy of air entering the heating coil, h₂ = Enthalpy of air leaving the heating coil, and hA = Enthalpy of air at the end of humidification process)?

1 Answers 5 Views

Resistance to heat flow by conduction is proportional to (where, t & ρ are thickness & density of the material respectively and A = area normal to the direction of heat flow. )?

1 Answers 5 Views

The process, which causes the air to enter the impeller blades of a centrifugal compressor at ________ velocity (without effecting the mass of air to flow and velocity of flow) is known as prewhirl.?

1 Answers 7 Views

A device in which some portion of waste heat of flue gases is recovered to heat the air before it passes to the furnace for combustion purpose, is known as?

1 Answers 4 Views

In case of unsteady fluid flow, conditions & flow pattern change with the passage of time at a position in a flow situation. Which of the following is an example of unsteady flow?

1 Answers 5 Views

In a heating process, a heat flow diagram in which the quantities of heat in the various items of a heat balance are represented by the width of a band is called the?

1 Answers 5 Views

Which of the following is not a continuous waste heat recovery equipment from the flue gases going out of furnace?

1 Answers 5 Views

LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is?

1 Answers 6 Views

Thermal conductivity based continuous flue gas analyser makes use of varying thermal conductivity of the constituents of flue gases. Which of the following constituents of flue gases has the maximum thermal conductivity?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)