In which of the following body shapes, the pressure drag is large compared to the friction drag?

Stream line body
Two dimensional body
Bluff body
None of these

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

Let'

4 views Answered 2022-09-01 13:21

Related Questions

A body of weight W is required to move up the rough inclined plane whose angle of inclination with the horizontal is α. The effort applied parallel to the plane is given by (where $$\mu $$ = $$\tan \varphi $$ = Coefficient of friction between the plane and the body)?

1 Answers 6 Views

The change in length due to a tensile or compressive force acting on a body is given by (where P = Tensile or compressive force acting on the body, $$l$$ = Original length of the body, A = Cross-sectional area of the body and E = Young's modulus for the material of the body)?

1 Answers 5 Views

Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?

1 Answers 4 Views

The inter-cooler pressure, for minimum work required, for a two stage reciprocating air compressor, is given by (where p₁ = Intake pressure of air, p₂ = Inter-cooler pressure, and p₃ = Delivery pressure of air)?

1 Answers 8 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.?

1 Answers 4 Views

The critical pressure ratio is given by (where p₁ = Initial pressure of steam, and p₂ = Pressure of steam at throat or critical pressure)?

1 Answers 4 Views

A body of weight ‘w’ placed on an inclined plane is acted upon by a force ‘P’ parallel to the plane which causes the body just to move up the plane. If the angle of inclination of the plane is ‘θ’ and angle of friction is ‘φ’, the minimum value of ‘P’, is?

1 Answers 7 Views

In which of the following the friction drag is generally larger than pressure drag?

1 Answers 5 Views

If a body is lying on a plane whose inclination with the horizontal is less than the angle of friction, then i. a force is required to move the body upwards ii. a force is required to move the body downward iii. the body will not be in equilibrium The correct answer is?

1 Answers 7 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)