The fluid in which the shearing stress within it is proportional to the velocity gradient across the sheared section, is called a __________ fluid.?

Bingham
Newtonion
Perfect
None of these

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

4 views Answered 2022-09-01 13:21

Related Questions

When a body is subjected to a direct tensile stress (σ) in one plane, then maximum normal stress occurs at a section inclined at _________ to the normal of the section.?

1 Answers 11 Views

When a body is subjected to a direct tensile stress ($$\sigma $$) in one plane, then tangential or shear stress on an oblique section of the body inclined at an angle $$\theta $$ to the normal of the section is?

1 Answers 5 Views

When a body is subjected to a direct tensile stress ($$\sigma $$) in one plane, then normal stress on an oblique section of the body inclined at an angle $$\theta $$ to the normal of the section is?

1 Answers 5 Views

When a body is subjected to two equal and opposite forces, acting tangentially across the resisting section, as a result of which the body tends to shear off across the section, the stress and strain induced is?

1 Answers 4 Views

A fluid is termed as the Newtonion fluid, when the shear stress is __________ the velocity gradient.?

1 Answers 6 Views

The given figure shows the Mohr's circle of stress for two unequal and like principal stresses (σx and σy) acting at a body across two mutually perpendicular planes. The normal stress on an oblique section making an angle θ with the minor principle plane is given by?

1 Answers 4 Views

In Newton's law of viscosity, which states that the shear stress is proportional to the __________ Co-efficient of viscosity is called dynamic or absolute viscosity(where, V = velocity, Vg = velocity gradient ).?

1 Answers 5 Views

A fluid which has a linear relationship between the magnitude of applied shear-stress and the resulting rate of deformation is called a/an __________ fluid.?

1 Answers 5 Views

The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.?

1 Answers 5 Views

If V, U and Vr represent the absolute velocity of fluid, velocity of blade, and relative velocity of fluid, and suffix ‘I’ and ‘o’ stand for entry and exit conditions, then in a rotary machine whose degree of reaction is unity?

1 Answers 7 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)