Which of the following is an independent variable for a batch tank reactor with uniform concentration and temperature?

Time
Useful volume of the tank
Diameter of the reactor
None of these

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

Let'

6 views Answered 2022-09-01 13:21

Related Questions

A tank with capacity T liters is empty. If water flows into the tank from pipe X at the rate of x liters per minute and water is pumped out by Y at the rate of y liters per minute and x > y, then how many minutes will the tank be filled?

1 Answers 5 Views

Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)?

1 Answers 6 Views

Batch files contain a group of MS-DOS commands that are run in successive order. What filename extension identifies batch files?

1 Answers 6 Views

Direction : Two statements I and II are given. These statement may be either independent causes or may be effects of independent causes or a common cause. One of these statements may be the effect of the other statements. Read both the statements and decide which of the following answer choice correctly depicts the relationship between these two statements. Mark answer : I. The price of vegetables have been increased considerably during this summer. II. There are tremendous increase in the temperature during this summer thereby damaging crops greatly.?

1 Answers 4 Views

A tank filled partially with a liquid is subjected to a uniform horizontal acceleration. Which of the following is true for the surface of liquid in the tank?

1 Answers 5 Views

Which of the following fixes the volume of a batch reactor for a particular conversion and production rate?

1 Answers 4 Views

If the solubilities of different components (in a liquid-liquid extraction system) increase with rise in temperature, then the temperature above which they dissolve completely is known as the critical solution temperature (CST or consolute temperature). If solubilities increase with decrease in temperature, then CST is the temperature below which they dissolve completely. If a binary system has no critical solution temperature, it implies that?

1 Answers 6 Views

Which of the following are true with regard to temperature control of the atmosphere of a given place I. The major temperature contrasts on earth's surface are between land masses and oceans II. During night, the water surface cools more rapidly than the land surface III. Temperature generally decreases with latitude on either side of the equator IV. Temperature rises to a maximum during summer and falls to a minimum during winter?

1 Answers 8 Views

Total costs in the short-term are classified into fixed costs and variable costs. Which one of the following is a variable cost?

1 Answers 4 Views

An assumption, which states that there must be linear relationship between independent variable and dependent variable is?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)