The process of removing metal by a cutter which is rotated in the same direction of travel of workpiece, is called?

Up milling
Down milling
Face milling
End milling

LohaHridoy

7 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

7 views Answered 2022-09-01 13:21

Related Questions

According to Fleming's right-hand rule for finding the direction of induced e.m.f., when middle finger points in the direction of induced e.m.f., forefinger will point in the direction of?

1 Answers 5 Views

A direction pole was situated on the crossing. Due to an accident the pole turned in such a manner that the pointer which was showing East, started showing South. One traveler went to wrong direction thinking to be West. In what direction actually he was traveling?

1 Answers 4 Views

If Dust is called Air, Air is called Fire, Fire is called Water, Water is called Colour, Colour is called Rain and Rain is called Dust, where do Fish live ?

1 Answers 4 Views

Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?

1 Answers 4 Views

One morning after sunrise, Vimal started to walk. During this walking he met Stephen who was coming from opposite direction. Vimal watch that the shadow of Stephen to the right of him (Vimal). To Which direction Vimal was facing?

1 Answers 4 Views

If Football is called Cricket, Cricket is called Basketball, Basketball is called Badminton, Badminton is called Volleyball, Volleyball is called Hockey and Hockey is called Golf, then which of the following games is not played using a ball?

1 Answers 6 Views

Which of the following permits a microwave signal to travel in one direction with virtually no loss, but severely attenuates any signal attempting to travel in the reverse direction?

1 Answers 5 Views

The process of removing metal by a cutter which is rotated against the direction of travel of workpiece, is called?

1 Answers 4 Views

In a plain milling cutter, the portion of the gash adjacent to the cutting edge on which the chip impinges is called?

1 Answers 4 Views

If a MAN is called GIRL, GIRL is called WOMAN, WOMAN is called BOY, BOY is called BUTLER and BUTLER is called ROGUE, who will serve in a restaurant ?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)