The value of shear stress which is induced in the shaft due to the applied couple varies?

From maximum at the center to zero at the circumference
From zero at the center to maximum at the circumference
From maximum at the center to minimum at the circumference
From minimum at the center to maximum at the circumference

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

4 views Answered 2022-09-01 13:21

Related Questions

The stress in the bar when the load is applied suddenly is __________ as compared to the stress induced due to gradually applied loads.?

1 Answers 5 Views

The stress induced in a body due to suddenly applied load compared to when it is applied gradually is?

1 Answers 5 Views

When a body is subjected to biaxial stress i.e. direct stresses ($${\sigma _{\text{x}}}$$) and ($${\sigma _{\text{y}}}$$) in two mutually perpendicular planes accompanied by a simple shear stress ($${\tau _{{\text{xy}}}}$$ ), then maximum shear stress is?

1 Answers 5 Views

When a body is subjected to a direct tensile stress ($${\sigma _{\text{x}}}$$) in one plane accompanied by a simple shear stress ($${\tau _{{\text{xy}}}}$$ ), the maximum shear stress is?

1 Answers 5 Views

The stress induced in a body, when suddenly loaded, is _________ the stress induced when the same load is applied gradually.?

1 Answers 5 Views

When a shaft, is subjected to torsion, the shear stress induced in the shaft varies from?

1 Answers 6 Views

According to maximum shear stress failure criterion, yielding in material occurs, when the maximum shear stress is equal to __________ times the yield stress.?

1 Answers 7 Views

The strain energy stored in a solid circular shaft subjected to shear stress ($$\tau $$), is: (Where, G = Modulus of rigidity for the shaft material)?

1 Answers 5 Views

The strain energy stored in a body due to shear stress, is (where $$\tau $$ = Shear stress, C = Shear modulus and V = Volume of the body)?

1 Answers 5 Views

The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)