Which of the following pipe joints would be suitable for pipes carrying steam?

Flanged
Threaded
Bell and spigot
Expansion

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

Let'

5 views Answered 2022-09-01 13:21

Related Questions

A device used in a boiler to control the flow of steam from the boiler to the main pipe and to shut off the steam completely when required, is known as?

1 Answers 6 Views

When the speed of the engine is controlled by means of a valve in a steam pipe, which regulates the pressure of steam entering the engine, then the governing is known as?

1 Answers 6 Views

According to Darcy's formula, the loss of head due to friction in the pipe is (where f = Darcy's coefficient, l = Length of pipe, v = Velocity of liquid in pipe, and d = Diameter of pipe)?

1 Answers 4 Views

The loss of head due to viscosity for laminar flow in pipes is (where d = Diameter of pipe, l = Length of pipe, v = Velocity of the liquid in the pipe, μ = Viscosity of the liquid, and w = Specific weight of the flowing liquid)?

1 Answers 5 Views

Number of vertical joints in a stretcher course is x times the number of joints in the header course, where x is equal to?

1 Answers 6 Views

A steam turbine, in which a part of the steam after partial expansion, is used for process heating and the remaining steam is further expanded for power generation, is known as?

1 Answers 4 Views

The needle beam method of tunnelling (i) Is suitable for soils in which roof can stand for few minutes without support (ii) Is suitable for brick lining (iii) Is suitable for concrete lining (iv) Requires large number of trench jacks?

1 Answers 5 Views

Which of the following parameters is not responsible for the heat loss from a hot steam carrying bare pipe surface located in a room without fans ?

1 Answers 11 Views

Welded joint is superior to revetted joint in respect of ease of fabrication, weight and strength. Which of the following joints is the most suitable for pipes carrying fluids under high pressure and temperature?

1 Answers 4 Views

Consider two pipes of same length and diameter through which water is passed at the same velocity. The friction factor for rough pipe is f₁ and that for smooth pipe is f₂. Pick out the correct statement.?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)