If a shaft made from ductile material is subjected to combined bending and twisting moment, calculations based on which one of the following failure theories will give the most conservative value?

Maximum principal stress theory
Maximum shear stress theory
Maximum strain energy theory
Maximum distortion energy theory

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

Let'

4 views Answered 2022-09-01 13:21

Related Questions

The design calculations for members subject to fluctuating loads with the same factor of safety, yield the most conservative estimates when using?

1 Answers 11 Views

When a shaft is subjected to combined twisting moment (T) and bending moment (M), then the equivalent twisting moment is equal to?

1 Answers 5 Views

When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be?

1 Answers 7 Views

When a shaft is subjected to a twisting moment, every cross-section of the shaft will be under?

1 Answers 5 Views

When a shaft, is subjected to torsion, the shear stress induced in the shaft varies from?

1 Answers 6 Views

The natural frequency of free torsional vibrations of a shaft is equal to (where q = Torsional stiffness of the shaft and $$I$$ = Mass moment of inertia of the disc attached at the end of a shaft)?

1 Answers 6 Views

The radius of a friction circle for a shaft rotating inside a bearing is (where r = Radius of shaft and $$\tan \varphi $$ = Coefficient of friction between the shaft and bearing)?

1 Answers 15 Views

Soderberg relation is based on __________ of the material whereas all other failure relation for dynamic loading are based on ultimate strength of the material.?

1 Answers 4 Views

The strain energy stored in a solid circular shaft subjected to shear stress ($$\tau $$), is: (Where, G = Modulus of rigidity for the shaft material)?

1 Answers 5 Views

The strain energy stored in a solid circular shaft in torsion, subjected to shear stress ($$\tau $$), is: (Where, G = Modulus of rigidity for the shaft material)?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)