Which of the following equipment provides fluctuating load?

Exhaust fan
Lathe machine
Welding transformer
All of the above

LohaHridoy

13 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

Let'

13 views Answered 2022-09-01 13:21

Related Questions

The design calculations for members subject to fluctuating loads with the same factor of safety, yield the most conservative estimates when using?

1 Answers 11 Views

When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)?

1 Answers 10 Views

The law of the machine is (where P = Effort applied to lift the load, m = A constant which is equal to the slope of the line, W = Load lifted, and C = Another constant which represents the machine friction.)?

1 Answers 4 Views

Direction : Two statements I and II are given. These statement may be either independent causes or may be effects of independent causes or a common cause. One of these statements may be the effect of the other statements. Read both the statements and decide which of the following answer choice correctly depicts the relationship between these two statements. Mark answer : I. Rural and semi-urban areas in the country have been suffering due to load shedding for quite some time. II. If the Government is not able to overcome the power crisis, load shedding will be extended even to the urban areas.?

1 Answers 9 Views

In an ac circuit, power to the load peaks at the frequency at which the load impedance is the complex conjugate of the output impedance.?

1 Answers 5 Views

D.C. motor is to a drive a load which is almost nil for certain part of the load cycle and peak value for short duration. We will select this?

1 Answers 11 Views

A load which is spread over a beam in such a manner that it varies uniformly over the whole length of abeam is called uniformly ________ load.?

1 Answers 6 Views

Which of the following boiler is best suited to meet the fluctuating demand of steam?

1 Answers 9 Views

Which of the following boilers is best suited to meet fluctuating demands?

1 Answers 5 Views

Following the six-tenth factor rule, if a log-log plot of capacity of the equipment vs. cost of the equipment is made, then a straight line is obtained, whose slope is equal to?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)