Pressure difference between two points in vessels, pipelines or in two different pipelines can be measured by a differential manometer. The pressure difference measured as the mm of water coloumn in case of mercury-water, differential manometer is equal to (where, H = difference in height of mercury column in mm).?

H
12.6 H
13.6 H
14.6 H

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

5 views Answered 2022-09-01 13:21

Related Questions

What is the printout of the following switch statement char ch = 'a'; switch (ch){ case 'a': case 'A': System.out.print(ch); break; case 'b': case 'B': System.out.print(ch); break; case 'c': case 'C': System.out.print(ch); break; case 'd': case 'D': System.out.print(ch); }?

1 Answers 6 Views

Battening is preferable when thei) column carries axial load onlyii) space between the two main components is not very largeiii) column is eccentrically loaded The correct answer is?

1 Answers 7 Views

For the manometer set up shown in the figure, the pressure difference PA - PB is given by?

1 Answers 4 Views

The inter-cooler pressure, for minimum work required, for a two stage reciprocating air compressor, is given by (where p₁ = Intake pressure of air, p₂ = Inter-cooler pressure, and p₃ = Delivery pressure of air)?

1 Answers 8 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

If the length of a combined footing for two columns l meters apart is L and the projection on the left side of the exterior column is x, then the projection y on the right side of the exterior column, in order to have a uniformly distributed load, is (where x̅ is the distance of centre of gravity of column loads).?

1 Answers 20 Views

The location of centre of pressure, which defines the point of application of the total pressure force on the surface, can be calculated by applying the principle of moments according to which "sum of the moment of the resultant force about an axis is equal to the sum of the components about the same axis". The centre of pressure of a rectangular surface (of width 'w') immersed vertically in a static mass of fluid is at a depth of(where, y = depth of the liquid)?

1 Answers 6 Views

Small furnace draught is accurately measured by an inclined tube manometer, in which the manometric liquid used most commonly is?

1 Answers 5 Views

A mercury thermometer can not be used to measure the temperature below the freezing point of mercury, which is __________ °C.?

1 Answers 5 Views

Of the pressure vessels, with same thickness but different diameters, which one withstands higher pressure?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)