The equivalent diameter for pressure drop calculation for a duct of square cross-section is given by(where, x = each side of the square duct)?

x
πx
2x
x/2

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

Let'

5 views Answered 2022-09-01 13:21

Related Questions

Two beams, one of circular cross-section and the other of square cross-section, have equal areas of cross-sections. When these beams are subjected to bending,?

1 Answers 5 Views

According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through center of gravity (i.e. $$I$$P) is given by (where, A = Area of the section, $$I$$G = Moment of inertia of the section about an axis passing through its C.G. and h = Distance between C.G. and the parallel axis.)?

1 Answers 6 Views

The inter-cooler pressure, for minimum work required, for a two stage reciprocating air compressor, is given by (where p₁ = Intake pressure of air, p₂ = Inter-cooler pressure, and p₃ = Delivery pressure of air)?

1 Answers 8 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.?

1 Answers 4 Views

The critical pressure ratio is given by (where p₁ = Initial pressure of steam, and p₂ = Pressure of steam at throat or critical pressure)?

1 Answers 4 Views

The pressure drop per unit length for laminar flow of fluid through a long pipe is proportional to (where, A = cross-sectional area of the pipe & D = Diameter of the pipe)?

1 Answers 4 Views

In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)?

1 Answers 7 Views

The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area 'A' is given by (where, P = perimeter of the channel in contact with the fluid)?

1 Answers 5 Views

If D is the diameter of a circular sewer and D’ is the top horizontal diameter of an equivalent egg shaped section, the relationship which holds good, is?

1 Answers 9 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)