The air standard efficiency of an I.C. engine is given by (where r = Compression ratio, and γ = Ratio of specific heats)?

1 - rγ - 1
1 + rγ - 1
1 - (1/rγ - 1)
None of these

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

The air standard efficiency of an I.C. engine is given by 1 - (1/rγ - 1) where r = Compression ratio, γ = Ratio of specific heats

4 views Answered 2022-09-01 13:21

Related Questions

The index of compression ‘n’ tends to reach ratio of specific heats ‘y’ when?

1 Answers 8 Views

The efficiency of a Carnot heat engine operating between absolute temperatures T₁ and T₂ (when, T₁ > T₂) is given by (T₁ - T₂)/T₁. The co-efficient of performance (CO.P.) of a Carnot heat pump operating between T₁ and T₂ is given by?

1 Answers 4 Views

The temperature at which a gas, when subjected to Joule-Thomson expansion, neither cools or heats up, is termed as the __________ temperature. Above this temperature the gas heats up on throttling and below this the gas cools down.?

1 Answers 6 Views

The efficiency of a Carnot heat engine operating between absolute temperatures T₁ and T₂ (when, T₁ > T₂) is given by (T₁ - T₂)/T₁. The co-efficient of performance (C.O.P.) of a Carnot heat pump operating between T₁ and T₂ is given by?

1 Answers 5 Views

The air standard efficiency of an Otto cycle is given by (where r = Compression ratio, and γ = Ratio of specific heats)?

1 Answers 5 Views

If p₁, is the pressure of air entering the L.P. cylinder and p₂ is the pressure of air leaving the L.P. cylinder (or inter-cooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D₁ = Dia. of L.P. cylinder, and D₂ = Dia. of H.P. cylinder)?

1 Answers 6 Views

The stage efficiency (ηS) is given by (where ηB = Blading efficiency, and ηN = Nozzle efficiency)?

1 Answers 4 Views

Various efficiencies of a centrifugal pump are related as (where, ηm = mechanical efficiency ηv = volumetric efficiency. ηma = manometric efficiency ηo = overall efficiency)?

1 Answers 7 Views

Which one of the following event would reduce volumetric efficiency of a vertical compression ignition engine?

1 Answers 4 Views

Highest useful compression ratio (HUCR) is the highest compression ratio at which the?

1 Answers 8 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)